Learn how to resolve sealing issues on the Connect+ 500W, Connect+ 1000, Connect+ 2000, Connect+ 3000, SendPro P1000, SendPro P1500, SendPro P2000, and SendPro P3000.
Products affected: Connect+ 500W, Connect+ 1000, Connect+ 2000, Connect+ 3000, SendPro P1000, SendPro P1500, SendPro P2000, SendPro P3000
Follow these steps to correct problems with sealing envelopes:
If an 'Out of E-Z Seal' message is displayed:
Check the brush:
If the moistener brush is dry follow the same steps as Out of E-Z Seal.
If the moistener brush is dirty:
If an 'Out of E-Z Seal' message is displayed:
- Make sure that the sealer bottle is seated properly in the holder.
Check the brush:
- Connect® +500W, 1000, and 2000 / SendPro™ 1000, 1500, and 2000: Press the blue button on the feed deck, then pull the brush out.
- Sealing Envelopes on the Connect+® 3000 / SendPro™ 3000: Lift the jam release out of the way, then lift the blue handle on the feed deck. The brush assembly will then slide out.
- Sealing tapes with the optional tape moistening unit on the Connect+® 3000 / SendPro™ 3000: Put the blue lever nearest you to the right and pull the brush assembly out.
If the moistener brush is dry follow the same steps as Out of E-Z Seal.
If the moistener brush is dirty:
- Remove the moistener brush.
- Clean the moistener brush with plain water and rinse it thoroughly.
- Reinstall the moistener brush.
- Remove mail from the drop stacker.
- Examine mail pieces and ensure that each envelope flap is seated flat against the body of the envelope.
- If necessary, tap the mail on the table to ensure all the mail pieces are even with each other.
- With the mail facing you, run your hand across the top of the stack while squeezing the stack together. Repeat this process as needed.
- Allow the envelopes to dry undisturbed.
Comments
0 comments
Please sign in to leave a comment.